Rautheon UW50PV Manual De Operation página 19

Display Interpretations (Continued)
W3 Wash 3 (no agitation)
W4 Wash 4 (medium reversing action)
W5 Wash 5 (temp.-controlled cool-down)
W6 Wash 6 (extra low agitation)
W7 Wash 7 (no agitation, drain 1 open,
no refill)
WF Warm flush
WH Warm fill to high level
WM Warm fill to medium level
WL Warm fill to low level
WO Warm fill to overflow level
WR Warm rinse
• Left dot – poor balance condition
• Second dot from left – door lock switch
• Third dot from left – program mode
• Fourth dot from left – high level
reached
• Fifth dot from left – medium level
reached
• Right dot – low level reached
EXISTS Cycle already in memory
EDIT? Do you want to edit the cycle?
TEMP Over-temperature-limit condition
OVERHT Open or shorted temperature input
circuit or temperature out of
computer's allowable limits
WATER Water in washer-extractor at end of
cycle
°FAR Temperature in degrees Fahrenheit
°CEN Temperature in degrees Centigrade
MANUAL Manual Mode enabled
F232050
Display Interpretations (Continued)
NO MAN Manual Mode disabled
1DRAIN One drain capability selected
2DRAIN Second independent drain enabled (via
Auxiliary 2 output – precludes control
of recirculation pump via Auxiliary 2,
if selected). This should not be
confused with the "dual drain" option.
ADV Advance (skip steps) feature enabled
NO ADV Advance feature disabled
WET CL Wet clean function for Auxiliary 1
output (1/2 wash speed) and Auxiliary
2 output (recirculation pump) enabled
(See "2DRAIN.")
NO WCL Wet clean function for Auxiliary 1 and
2 disabled (Auxiliary 1 and 2 are
timed outputs.)
S BAL "Short" balance routine – active only if
inverter drive load balance sensing is
utilized.
L BAL "Long" balance routine – active only if
AC inverter drive load balance sensing
is utilized.
Operation
17