Programming a Supply Step – Models
with 5 Supplies
The WE-6 microcomputer is capable of
controlling up to 5 separate supplies and up to 31
various combinations of the 5 supplies. (See the
Supply Display Codes Table in this subsection
for a listing of the energized supply
compartments represented by each display code.)
1. The computer must be in the PROGRAM
mode and the cycle programming sequence
must be ready for the next step.
2. Press the Supply key. The display will read
"S." Now press the number key – 1, 2, 3, 4,
or 5 – that corresponds to the desired
supply valve.
If multiple simultaneous supply injections
are desired, follow this procedure:
• After the Supply key has been pressed,
press any combination of keys 1 – 5 (up
to 5 individual digits per step) before
pressing the Enter key.
• The computer will add those numbers to
the supply step. All desired supplies will
be turned on for the amount of time
programmed.
The display will show either a letter or
number code to indicate the supply
combination selected. For example, assume
the computer is in the program mode and
the Supply key has been pressed. Keys 1, 2
and 5 will be pressed one at a time. After
the last key is pressed, the display will read
"SN" as the first two digits of the display,
followed by the step number, which is then
followed by the cycle number being
programmed. Press the Enter key. The
display will read
"M---S." Now assign the desired time in
minutes and seconds for the supply
injection to last.
3. Press the Enter key and go to the next step
in the cycle.
F232050
Programming
Supply Display Codes (5 Supplies)
Code
1
2
A
3
B
C
D
4
E
F
H
I
J
L
M
5
6
7
N
8
O
P
Q
9
R
S
T
U
V
W
X
Supply Number
0 = Supply Off
X = Supply On
5 4 3 2 1
0 0 0 0 X
0 0 0 X 0
0 0 0 X X
0 0 X 0 0
0 0 X 0 X
0 0 X X 0
0 0 X X X
0 X 0 0 0
0 X 0 0 X
0 X 0 X 0
0 X 0 X X
0 X X 0 0
0 X X 0 X
0 X X X 0
0 X X X X
X 0 0 0 0
X 0 0 0 X
X 0 0 X 0
X 0 0 X X
X 0 X 0 0
X 0 X 0 X
X 0 X X 0
X 0 X X X
X X 0 0 0
X X 0 0 X
X X 0 X 0
X X 0 X X
X X X 0 0
X X X 0 X
X X X X 0
X X X X X
45