Displaying Individual Cycle Usage; Editing A Cycle - Rautheon UW50PV Manual De Operation

Programming
Cycle Programming
6. Press the Advance key to move to the next
step of the cycle. To access further
information pertaining to each step (for
example, temperature and/or time), press
the Enter key. If the display shows a
temperature, press the Enter key again to
display the time. Press the Enter key once
more to advance to the next step.
7. At the end of the cycle, the computer will
display "END-25" for two seconds and
return to the normal programming mode.
8. Return the program mode switch to the
RUN position and remove the key.
Note: Never press the Clear key while
displaying a cycle in memory except to
edit or delete a step.

Displaying Individual Cycle Usage

1. Insert key into the program mode switch
(located on the left side of the control
module) and turn key to the PROGRAM
position. The display will read "CYC00."
2. Press the Edit Cycle key on the keypad.
The display will read "DCYC00."
3. Press the two-digit code to display the
desired cycle number: For example, press
key 2 and then key 5 to select cycle 25.
4. Press the Enter key. The display will show
"xx25." (The "xx" here stands for the
number of times cycle 25 has been run and
will be represented by numbers in the
actual display.)
The computer will remain in this step
until one of the following options has
been chosen:
40
(Continued)
• Press the Enter key to continue
displaying the cycle, OR
• Press the Clear key to return to the
normal program mode, OR
• Press key 0 to reset the counter for
this cycle to zero, OR
• Take the computer out of the
program mode.

Editing a Cycle

To edit a cycle in memory or to change, add,
or delete a step:
1. Insert key into the program mode switch
(located on the left side of the control
module) and turn key to the PROGRAM
position. The display will read "CYC00."
2. Press the Edit Cycle key on the keypad.
The display will read "DCYC00."
3. Press the two-digit code for the cycle
requiring editing: For example, press
key 2 and then key 5 to select cycle 25.
4. Press the Enter key. The computer will
search for cycle information for this cycle.
If no cycle information exists, the
computer will flash "NCYC25" followed
by "ADD?" To add this cycle, press the
Enter key and proceed to the add cycle
programming mode. If adding this cycle
is not desired, press the Clear key. The
computer will then return to the normal
programming mode.
5. If cycle information does exist for cycle
25, the computer will display "0425," for
example, to indicate that cycle 25 has been
run four times. To clear the count (reset it
to zero), press key 0. The display will
then show "0025."
F232050