Before Cutting - Metabo HPT C 3607DRA Manual De Instrucciones

be familiar with, and prepared for, the operational
characteristics of the tool may cause serious
injury.
8. Trial Run
After confi rming that no one is standing behind,
the power tool start and confi rm that no operating
abnormalities exist before attempting a cutting
operation.
9. Inspect the rotating stability of the saw blade.
For precise cutting, rotate the saw blade and check for
defl ection to confi rm that the blade is not noticeably
unstable; otherwise vibrations might occur and cause
an accident.
AC/DC adapter
1. Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation are adequate.
2. To prevent electric shock, connect to a power source
equipped with a ground fault circuit breaker.
3. Prior to use, make sure that the DC cord insulation is
not torn or that the case is not cracked.
Do not use the product if there is a break in the DC
cord, the insulation is torn, or the case is damaged.
4. Before starting operation, make sure that the vicinity
of the box's vent is free from any wood shavings or
iron powder.
Also, do not use in locations where iron powder is
abundant, or in areas where there is rain, snow or
other water sources that could wet the product.
5. Make sure there are no solid metal material or liquid
in the adapter box. Failure to do so may result in
damage.
6. Be careful not to step on the box. Also, make sure the
box is placed in a location where it won't be stepped
on. Do not place in a location where the box could be
immersed in water when it rains.

BEFORE CUTTING

1. Cutting a groove on the table insert (Fig. 16)
A groove has to be cut in the table insert, before
starting operation. Secure a piece of wood about
300 mm (12") wide to the turntable with the vise
assembly, to prevent the breakage of the table insert.
After the switch has been turned on and the saw blade
has reached its maximum speed, slowly lower the
handle to cut the piece of wood, and then a groove on
the table insert.
Table
Insert
Vise assembly
CAUTION
Do not cut the groove too quicky; otherwise the
guard might become damaged.
2. Positioning the table insert
Workpiece
5 mm machine screw
[Right angle cutting]
Fig. 17-a
Saw blade
Workpiece
[Left bevel angle cutting]
Fig. 17-b
Table Insert Saw blade
5 mm machine screw
[Right bevel angle cutting]
Fig. 17-c
English
Turntable
Fig. 16
Saw blade Table Insert
Turntable
Table Insert
5 mm machine screw
Workpiece
21