Metabo HPT C 3607DRA Manual De Instrucciones página 23

Tighten
Clamp lever
Press at 0°
(right angle)
Set pin (A)
8 mm set screw
(Stopper for 0°)
Fig. 19-a
Indicator
(For left bevel
scale)
Fig. 19-b
5. Confi rmation for use of sub fence (A) (Fig. 20-a)
WARNING
When right angle cutting, loosen the 6 mm knob
bolt, then slide the sub fence (A) outward and
remove it.
Failure to do so may result in the main body or
saw blade coming into contact with the sub fence
(A) and causing injury.
This power tool is equipped with a sub fence (A).
In the case of direct angle cutting and left bevel angle
cutting, use the sub fence (A). Then, you can realize
stable cutting of the material with a wide back face.
Indicator
(For right bevel scale)
Loosen
6 mm bolt (A)
(Stopper for left 45°
bevel angle)
Pull out when
slanted to the
right
Set pin (A)
6 mm bolt (B)
(Stopper for right
45° bevel angle)
When right angle cutting, loosen the 6 mm knob bolt,
then remove sub fence (A). Failure to do so may result
in the main body or saw blade coming into contact
with the sub fence (A) and causing injury.
6 mm knob bolt Fence (A)
Fig. 20-a
NOTE
When transporting the saw, always secure the sub
fence (A) in the collapsed position and lock it.
6. Confi rmation for use of sub fence (B) (Fig. 20-b)
WARNING
When left angle cutting, loosen the 6 mm knob
bolt, then slide the sub fence (B) outward. Failure
to do so may result in the main body or saw blade
coming into contact with the sub fence (B) and
causing injury.
This power tool is equipped with a sub fence (B). In
the case of direct angle cutting and right bevel angle
cutting, use the sub fence (B). Then, you can realize
stable cutting of the material with a wide back face.
When left angle cutting, loosen the 6 mm knob bolt,
then slide the sub fence (B) outward, as shown in
Fig. 20-b.
Sub fence (B)
Fence (B) 6 mm knob bolt
Fig. 20-b
NOTE
When transporting the saw, always secure the sub
fence (B) in the collapsed position and lock it.
English
Sub fence (A)
23