Practical Applications - Metabo HPT C 3607DRA Manual De Instrucciones

The laser line is adjusted to the width of the saw blade
at the time of factory shipment. Adjust the positions of
the saw blade and the laser line taking the following
steps to suit the use of your choice.
ON OFF
Vise assembly
Switch
(For laser marker)
(1) Light up the laser marker and make a groove of about 5
mm deep on the workpiece that is about 20 mm in height
and 150 mm in width. Hold the grooved workpiece by
vise as it is and do not move it. For grooving work, refer
to "13. Groove cutting procedures" on page 35.
(2) Then, turn the adjuster and shift the laser line. (If you
turn the adjuster clockwise, the laser line will shift to
the right and if you turn it counterclockwise, the laser
line will shift to the left.) When you work with the ink
line aligned with the left side of the saw blade, align
the laser line with the left end of the groove (Fig. 23).
When you align it with the right side of the saw blade,
align the laser line with the right side of the groove.
(3) After adjusting the position of the laser line, draw a
right-angle ink line on the workpiece and align the ink
line with the laser line. When aligning the ink line, slide
the workpiece little by little and secure it by vise at a
position where the laser line overlaps with the ink line.
Work on the grooving again and check the position
of the laser line. If you wish to change the laser line's
position, make adjustments again following the steps
from (1) to (3).
NOTE
Check and make sure on a periodic basis if the position
of the laser line is in order. As regards the checking
method, draw a right-angle ink line on the workpiece
with the height of about 20 mm and the width of 150 mm,
and check that the laser line is in line with the ink line
[The deviation between the ink line and the laser line
should be less than the ink line width (0.5 mm)]. (Fig. 24)
Adjuster
(For laser marker)
Move
Groove Laser line
Fig. 23
Laser line Marking

PRACTICAL APPLICATIONS

WARNING
● To avoid personal injury, never remove or place
a workpiece on the table while the tool is being
operated.
● Never place your limbs inside of the line next to
warning sign while the tool is being operated.
This may cause hazardous conditions (see
Fig. 25).
CAUTION
○ It is dangerous to remove or install the workpiece
while the saw blade is turning.
○ When sawing, clean off the shavings from the
turntable.
○ If the shavings accumulate too much, the saw blade
from the cutting material will be exposed. Never
subject your hand or anything else to go near the
exposed blade.
NOTE
Prior to operating the switch, make sure to check the
stability of the tool by setting the angle and turn to
conduct a trial cutting run without using a workpiece.
Line Warning sign
Warning sign Line
English
(pre-marked)
Fig. 24
Fig. 25
25