Preparation Before Operation - Metabo HPT C 3607DRA Manual De Instrucciones

English
APPLICATIONS
Cutting various types of wood.

PREPARATION BEFORE OPERATION

CAUTION
Pull out battery before carrying out any
adjustment, servicing or maintenance.
When fi nished with a job, pull out the battery.
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the
battery installed to power tool while the switch is in
the ON position, the power tool will start operating
immediately, which could cause a serious accident.
3. Remove all packing materials attached or connected
to the tool before attempting to operate it.
4. Releasing the locking pin (Fig. 7)
When the power tool is prepared for shipping, its main
parts are secured by a locking pin.
Move the handle slightly so that the locking pin can be
disengaged.
During transport, lock the locking pin into the gear case.
2
Locking pin
5. Installing the sub tables (Standard accessory) (Fig. 8)
The sub tables help keep longer workpieces stable
and in place during the cutting operation.
(1) Loosen the 6 mm hex. socket bolts with 5 mm hex.
bar wrench (standard accessory). Insert the holder
into the base.
(2) Use a steel square for aligning the upper surface of
the sub tables with the base surface.
Turn the set screws, and adjust the height of the sub
tables.
(3) After adjustment, fi rmly tighten the 6 mm knob bolts
and fasten the holder with the 6 mm hex. socket bolts.
If the length of set screws is insuffi cient, spread a thin
plate beneath.
16
3
1
Handle
Fig. 7
6 mm hex. socket bolt
Sub table assembly
6 mm knob Bolt
Steel square
Holder
Set screw
CAUTION
○ When transporting or carrying the tool, do not
grasp the sub tables or holders.
○ There is the danger of the sub tables or holders
slipping out of the base. Grasp the carry handle
instead of the sub tables or holders.
6. Installing the side handle (Fig. 2)
Install the side handle that came enclosed with this
unit.
7. Attach the dust bag to the main unit (Fig. 3)
8. Installation (Fig. 9, 10)
3 – ø9 mm
3-3/4"
(95 mm)
Side of the side handle
5/16
Base
Work bench
Base
Fig. 8
4-15/16"
(125 mm)
8 mm) bolt
" (
5/16 8 mm) nut
" (
Fig. 9