Operating Instructions - Rotary SPOA10NB Instrucciones De Instalación

To avoid personal injury and/or property damage, permit only trained personnel to operate lift. After
WARNING
reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before
loading vehicle on lift.
Always lift the vehicle using all four adapters. NEVER raise just one end, one corner, or one side of
IMPORTANT
vehicle.
SAFETY
CAUTION
INSTRUCTIONS
? ?
?
Lift to be used
Read operating
by trained operator
and safety manuals
only.
before using lift.
©
CAUTION
Use vehicle
Remain clear of lift
manufacturer's
when raising or
lift points.
lowering vehicle.
©
Observe and heed Safety, CAUTION and Warning labels on
1. Before Loading: Lift must be fully lowered and service
bay clear of all personnel before the vehicle is brought
on lift. Swing arms out to full drive-thru position.
2. Spot vehicle over lift with left front wheel in proper
spotting position, Fig. 1.
3. Loading: Swing arms under vehicle and position
adapters at vehicle manufacturer's recommended lift
points, Fig. 2. Use intermediate, high step, or optional
adapters for under body clearance when required.
Note: Allow (2) seconds between motor starts. Failure to
comply may cause motor burnout.
IMPORTANT DO NOT rest adapter against edge of arm.
DO NOT REST ADAPTER
AGAINST EDGE OF ARM

OPERATING INSTRUCTIONS

CAUTION
Authorized personnel
only in lift area.
©
WARNING
©
the lift.
4. To Raise Lift:
A. For all lifts. Push Raise switch on power unit, Fig. 3.
B. Stop before making contact with vehicle. Check
arm restraint pins for engagement. If required,
slightly move arm to allow restraint gear and pawl
to mesh. DO NOT hammer pin down as this will
damage the restraint gear teeth.
C. Raise vehicle until tires clear the floor.
D. Stop and check adapters for secure contact at
©
vehicle manufacturer's recommended lift points.
E. Continue to raise to desired height only if vehicle is
secure on lift.
F. Do Not go under vehicle if all four adapters are
not in secure contact at vehicle manufacturer's
recommended lift points.
G. Repeat complete spotting, loading and raising
procedures if required.
H. Lower lift onto locking latches.
*Maximum operation pressure is:
2103 psi (14500 kPa) for SPOA7
2755 psi (18995 kPa) for SPO9, SPOA9
2755 psi (18995 kPa) for SPO10, SPOA10, SPOA10NB
CAUTION
Use height extenders
when necessary
to ensure
good contact. ©
4
Center of Lift
CAUTION
Auxiliary adapters Clear area if vehicle
may reduce
is in danger of falling.
load capacity.
©
WARNING
©