Maintenance; Preparation And Follow-Up Tasks; Maintenance And Cleaning; Regular Maintenance Work - HellermannTyton TT4030 Manual De Instrucciones

Maintenance

9 Maintenance
The following warning instructions apply for all
maintenance work.
DANGER
Danger of lethal electric shock!
There is a risk of lethal injury when touching live
components.
f Switch off the device before maintenance work.
f Pull the power plug out of the socket.
CAUTION
Risk of injury through improper work!
Safe working on the device requires specialised knowledge.
Improperly performed maintenance work can cause injuries.
f Perform maintenance work professionally.
f If necessary, have the maintenance performed by an
authorised specialised technician.
NOTE
Material damage caused by improper work!
Safe working on the device requires specialised knowledge.
Improperly performed maintenance work can cause damage
to the device.
f Perform maintenance work professionally.
f If necessary, have the maintenance performed by an
authorised specialised technician.
Maintenance serves to preserve operational readiness
and to prevent premature wear.
Maintenance is divided into:

• Maintenance and cleaning

• Service

9 .1 Preparation and follow-up tasks

For all maintenance work, proceed as follows:
1 Switch off the device using the main switch.
2 Pull the power plug out of the socket.
; The device is without current.
3 Perform the required maintenance.
4 Insert the mains plug into the socket.
5 Switch on the device using the main switch.
; The device is ready for operation.
20
Operating Instructions • Thermal Transfer Printer TT4030 • 06-2017 • 031-93478
9 .2 Maintenance and cleaning

9 .2 .1 Regular maintenance work

To ensure proper operational status of the device,
defined maintenance work must be performed at the
prescribed intervals.
f With daily use, perform the following regular
maintenance work.
Interval Maintenance work
Weekly Clean the thermal printhead
Monthly Clean the device
Yearly Device maintenance

9 .2 .2 Cleaning agents and materials

The following cleaning agents and materials are required
for maintaining the device:
• All-purpose cleaner
• Lint-free cloth
• Soft brush
• Vacuum cleaner

9 .2 .3 Cleaning the device

NOTE
Material damage due to improper cleaning!
The device can be damaged by using aggressive cleaning
agents.
f Do not use abrasive cleaners or solvents to clean the
external surfaces or components.
Proceed as follows:
1 Remove dust and paper fluff from the print area using a
soft brush or vacuum cleaner.
2 Clean exterior surfaces with a general purpose cleaner
and a cloth.
; The device is cleaned.

9 .2 .4 Cleaning the print roller

Soiling on the print roller can cause problems with the
print image and material transport.
Proceed as follows:
1 Lift the printhead.
2 Take the materials and colour ribbon out of the device.
3 Remove deposits with roller cleaner and a lint-free cloth.
4 If the roller is damaged, have it replaced.
Æ Service instructions
; The print roller is cleaned.