Extension @ Shock & Flip Chip; Shock Setup Data - Turbo KENEVO Manual De Usuario

9.1
Fig. 9.1: Place the Flip Chip eccentric sleeves inside the lower shock eye, in the High or Low mounting position.
„
Fig. 9.1: Align the shock eye with the extension hole, then install the bolt/nut.
„
All models are assembled with the Flip Chip in the Low position. Switching to the High position
raises the bottom bracket height by approximately 5-6mm and steepens the head tube angle by
approximately 0.5 degrees.
Place a rag between the link and the seat tube to make sure the link doesn't make contact with the
seat tube.
Remove the upper shock eye bolt and the two extension bolts, then remove the extension/shock assembly from
„
the bike.
Remove the lower shock eye bolt, then remove the Flip Chip halves out of the lower shock eye.
„
Rotate the Flip Chip halves 180 degrees then push them back into the lower shock eye.
„
Assemble the rear shock eye to the extension and install the bolt (do not torque at this time).
„
Install then torque to specification the upper shock eye bolt and the two extension bolts.
„
Torque the lower shock eye bolt to specification.
„
DATE
RIDER WEIGHT
FORK PSI
FORK REBOUND (# of clicks from full slow)
FORK COMPRESSION (# of clicks from full firm)
SHOCK REBOUND (# of clicks from full slow)
19
9.4. EXTENSION @ SHOCK & FLIP CHIP
FLIP CHIP
DO NOT TORQUE UNTIL THE
REAR TRIANGLE IS ASSEMBLED
AND TORQUED!

9.5. SHOCK SETUP DATA

FLIP CHIP
HIGH/LOW
POSITION