Publicidad
Idiomas disponibles
Idiomas disponibles
4. When using the 4x objective, you
can also vary the magnification be-
tween 25x and 200x by using the
digital zoom on the LCD module.
To do so, use the up and down
keys (, ) on the LCD module.
A display will appear on the left
side of the monitor that shows the
current zoom setting.
5. For higher magnifications, you have
to turn the objective nosepiece to
the setting of the 10x objective or
the 40x objective (maximum mag-
nification). After you change the
objective, you must focus the pic-
ture again. You can increase the
total magnification for each objec-
tive by using the digital zoom.
Attention: Before you change the
objective, move the mechanical
stage to the lowest position by us-
ing the focus knob. In this way, you
will not hit anything while turning the
nosepiece. Also, be careful when us-
ing the higher magnifications. If you
22
move the mechanical stage too close
to the objective lens, you could the
specimen could hit the objective and
there could be damage.
Digital Pictures
Basic Operations
Activation
If the unit is off, push the on/off
switch (see Fig. 3) and hold it for 1
or 2 seconds. The red monitor con-
trol light activates and the unit starts
working.
Deactivation
If the unit is on, push the on/off
switch (see Fig. 3) and hold it for 1
or 2 seconds. The red monitor con-
trol light goes out, and the unit shuts
down.
Adjustment
To change the current unit settings,
call up the menu by pressing the
menu key. Push the direction keys
to select the corresponding settings.
After choosing a setting, press the
OK key to confirm it.
Display on the LCD Monitor
By pressing the Esc key once or mul-
tiple times, you access different op-
erating modes. These are described
in the following.
Digital Photo Mode
Fig. 6
1 Digital photo mode symbol
2 Symbol of the built-in memory. If
you have inserted an SD card, the
Publicidad
