Panic Function; Anti-Hijack Function; Back-Up Battery Supply - Renault 6825 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 45
rev04
Operating instructions

7. PANIC FUNCTION

Sound and audible alarm can be triggered deliberately, e.g. with the purpose of deterring a thief buzzing around the vehicle. To do so, press
push-button n. 2 of the transmitter. Panic alarm can be stopped by pressing push-button n. 1. This function is selectable (see paragraph 13).

8. ANTI-HIJACK FUNCTION

This function has been studied in response to the fast growing phenomenon of hi-jacking, that is the forceful seizure of control aboard a
vehicle, which takes place typically while the driver is waiting before a stop sign or the traffi c lights.
The system switches to anti-hijack mode if the stolen vehicle is running and the victim of the seizure is still in possession of the remote
control transmitter with enabled Main-libre function.
After the coded signal from the transmitter has been absent for 2 min., the siren starts to sound, fi rst with weakened sound power,
subsequently with full sound power,and the turn indicators fl ash in an uninterrupted sequence of alarm cycles. When the vehicle ignition is
turned off, the complete security system arms itself automatically and starting becomes impossible. Disarming is only possible via the remote
control or the emergency disarming PIN code.
Remark: the same will happen if you get out of the transmitterrange while the ignition of your vehicle is on.
Important: to be able to benefi t from this function if required, do not forget to ALWAYS keep the transmitter with yourself. NEVER
attach it to the ignition key of the vehicle.
This function is also selectable, that is it can be enabled or disabled as chosen by the user. Please refer to the table included in paragraph
13, which provides general information about the possible confi gurations of the system (5 selectable functions).

9. BACK-UP BATTERY SUPPLY

The 6825 is equipped with internal Ni-MH back-up batteries that recharge with the run of the vehicle.
In the event that the power supply is interrupted (e.g. in the event that the cables of the vehicle battery are cut), the integrated back-up
battery will allow the alarm system to sound (if armed) and thus signal the sabotage. When the power supply is reinstated, the system sets
itself to the same status (armed/disarmed) as it was before the interruption.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido