Automatic Timed Switch-Off Function (Sleep Function); Emergency Disarming Via Pin Code - Renault 6825 Instrucciones De Uso

Operating instructions

14. AUTOMATIC TIMED SWITCH-OFF FUNCTION (SLEEP FUNCTION)

Although the current consumption rate of this security systems is extremely low, another special feature has been implemented with the
purpose of protecting the battery of your vehicle: the radio receiver that is integrated in the unit switches off automatically after the vehicle
has been unused for 7 days and the current consumption rate drops considerably. When it is in sleep condition, the alarm system does not
therefore react to the radio transmitter.
In order to reinstate the normal functions of the device:
• If the system is disarmed, turn ignition on;
• If the system is armed, turn ignition on and press push-button n. 1. If the transmitter is not available, enter the emergency disarming pin
code as described in paragraph 15. If turning the ignition on is not followed by pressing the transmitter on/off button or the pin code is not
entered correctly, the siren will sound.

15. EMERGENCY DISARMING VIA PIN CODE

In the event of loss or failure of the radio remote control, you can deactivate the security system by means of the procedure below, using the
PIN code you can fi nd on the last page of this manual or the code that you have possibly entered in replacement (see paragraph 15.2). The
last page of this manual includes also a quick description of the disarming procedure; we recommend that you record or apply the PIN code
there, then cut the card away and keep it in your wallet for future reference.
1. Turn ignition on. The alarm starts to sound.
2. Wait. The alarm stops. The LED switches off, then it starts to fl ash slowly.
3. Count the number of fl ashes. As soon as the number of fl ashes equals the fi rst number of your PIN code, turn ignition off (for example, if
the fi rst number of your code is 3, then wait for the LED to fl ash 3 times before turning the ignition OFF).
4. Within three s, turn ignition on again. Count the number of fl ashes. As soon as the number of fl ashes equals the second number of your
PIN code, turn ignition off (for example, if the second number of your code is 10, then wait for the LED to fl ash ten times before turning
the ignition OFF). The LED switches off.
5. Enter the remaining numbers of the PIN code using the same procedure.
end of the alarm cycle it will be possible to restart the procedure.
ONCE ALL THE DIGITS HAVE BEEN ENTERED CORRECTLY, THE SYSTEM DISARMS WITH A LONG BLEEP FOLLOWED BY FOUR
SHORTER AUDIBLE SIGNALS, THEN IT SWITCHES TO SERVICE MODE (see paragraph 10).
14
The LED switches off.
In the event of a mistake, an alarm cycle will follow. At the
rev04