Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ES
FR
ENG
1. SPECIFICATIONS
STABILISATION TIME
OPERATING TEMPERATURE
POWER SUPPLY (EXTERNAL)
POWER SUPPLY (INTERNAL)
INDICATOR HOUSING
SIGNAL INPUT RANGE
INTERNAL COUNTS
LOAD CELL DRIVE VOLTAGE
2. INSTALLATION
› The weighing indicator should be sited in location that will not degrade the accuracy.
› Avoid extremes of temperatures. Do not place in direct sunlight or near air conditioning vents.
› Avoid unsuitable table. The tables or floor must be rigid and not vibrate. Do not place near vibrating machinery.
› Avoid unstable power sources. Do not use near large users of electricity such as welding equipment or large motors.
› Avoid high humidity that might cause condensation. Avoid direct contact with water. Do not spray or immerse the scale in water.
› Keep the weighing indicator clean.
› Verify the voltage showing on the label matches the voltage in your area.
› Attach the mains cable to the connector on the side of the indicator. The power switch is located next to the mains inlet.
› Load cell connect as below (CUF 7 vias).
20
MODEL
BR70
RESOLUTION
1/15.000
1 seconds typical
0ºC - 40ºC / 32ºF - 104ºF
110/240 Vac, 50/60Hz
battery
CALIBRATION
automatic external
DISPLAY
6 digits of 24 mm / LCD with backlight
ABS plastic
ZERO RANGE
0mV ~ 5mV
0 ~ 15mV
ADC
Sigma delta
600.000
ADC UPDATE
Max 60 times/second
Max 5V/150mA
LOAD CELLS
up to four 350 ohms cells
DIMENSIONS
280x160x170 mm
For connection 4 pines, to bypass pines 1 with 2 and 5 with 6
1
6
2
7
5
3
4
BR70
Weight-tare indicator
User's guide
Publicidad
Tabla de contenido
