Puky Ceety Manual De Instrucciones página 10

Unpacking and scope of delivery
Do not use any sharp objects to open the
packaging or remove protective material.
You might accidentally damage the paint or
parts of the tricycle.
z Take all the parts out of the packaging.
z Remove the protective material. Keep all
packaging material out of the reach of
children; there is a risk of suffocation.
z Check that no parts are missing or dam-
aged. In case anything is missing, please
contact your specialized dealer before
starting any further work.
The CAT S2 delivery comprises (Figure A.1):
1. Frame, incl. rear axle, wheels
2. Fork, incl. front wheel and foot pedals
3. Handlebars
4. Seat
5. Insert
6. Tipper
7. Comfort push bar
8. Footrest
The CAT S6 delivery comprises (Figure A2):
1. Frame, incl. rear axle, wheels
2. Fork, incl. front wheel and foot pedals
3. Handlebars
4. Seat, incl. cushion, insert and belt system
5. Storage tray, incl. mesh bag
6. Comfort push bar, incl. shoulder bag
7. Footrest
Assembly
For assembly instructions, refer to the last
pages of this manual.
For assembly, you will need the following
tools (Figure B):
1. Open end wrench, 10 mm
2. Allen wrench, 5 mm
Small parts required during assembly (for
example screws and washers) should be kept
out of reach of small children. There is a risk of
suffocation if swallowed.
Assembly must be done carefully by an adult
to prevent accidents or injuries later on. Make
sure to take enough time for this. Some
assembly work requires manual dexterity and
familiarity with tools (i.e. wrenches.) If you are
not sure, please refer to your specialized
dealer or a workshop.
In some places, screws need to be tightened
with a specific torque. This torque is given in
newton meters (i.e. 2 Nm.). If a screw is tight-
ened with insufficient torque, the connection
may be too loose and unsafe. If the torque is
too great, screws and other parts can be
damaged or destroyed.
Figure 1: Remove transport restraint (rubber
band) and take off the washer.
Figure 2: Push fork shaft through the steering
head tube until the stop. Put the washer back
on.
Align the nibs on the fork shaft to face
backwards.
10