Stihl ADG 1 Manual De Instrucciones página 5

to modify the unit in any way since this
may result in accidents or damage to the
unit.
WARNING
Before using your battery analyzer, read
and fully understand all safety
precautions and instructions for the
STIHL AP battery.
Use only the original STIHL battery
analyzer.
Use only for analyzing geomretically
matching STIHL type AP batteries with a
maximum capacity of 10 Ah and a
maximum voltage of 42 V.
Do not test defective, leaking or
deformed batteries with the STIHL
battery analyzer.
Connect the unit only to an easily
accessible wall outlet with the voltage
and frequency specified on the rating
plate.
WARNING
To reduce the risk of personal injury,
never use an analyzer with damaged
housing, damaged power cord or
damaged plug. Do not operate the
analyzer if it has received a sharp blow,
been dropped or otherwise damaged in
any way.
Do not open or dissassemble analyzer –
there are no user serviceable parts
inside.
Store analyzer out of the reach of
children.
ADG 1
Protect from rain and
dampness. Keep dry.
Use and store only
indoors in dry rooms.
Operate analyzer at ambient
temperatures between 41 °F (5 °C) and
104 °F (40 °C).
Never bridge the contacts of the battery
analyzer with metallic objects (e.g. nails,
coins, jewelry) – short circuit. The unit
may be damaged by a short circuit.
In the event of smoke or fire in the unit,
disconnect it from the wall outlet
immediately.
WARNING
To reduce the risk of electric shock or
short circuit, do not insert any objects in
the unit's cooling slots.
WARNING
Do not operate in a hazardous location,
i.e. in a location where there are
combustible liquids (fumes), vapors or
dusts. Analyzers can produce sparks,
which may ignite the dust or vapors –
risk of explosion.
Check the analyzer's
power cord and plug reg-
ularly for damage. If the
power cord or plug is
damaged, immediately
disconnect the plug from
the wall outlet to avoid
the risk of electric shock.
Never jerk the power cord to disconnect
it from the wall outlet. To unplug, grasp
the plug, not the cord. Have a damaged
power cord repaired by an experienced
electrician.
Do not use the power cord for any other
purpose, e.g. for carrying or hanging up
the unit.
Never use power cords that do not
comply with regulations.
Make sure the power cord is located
and/or marked so that it will not be
stepped on, tripped over, come in
contact with sharp edges or moving
parts or otherwise subjected to damage
or stress.
An extension cord should not be used
unless absolutely necessary. If an
extension cord must be used, plug the
analyzer into a properly wired 16 gauge
(AWG 16) or heavier gauge extension
cord with blades that are the same
number, size and shapes as the blades
on the analyzer.
To reduce the risk of electric shock:
Always connect the unit to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power cord and plug is in good
condition.
Unplug the power cord from the outlet
when unit is not in use.
English
3