Connecting Analyzer To Power Supply; Selecting Language - Stihl ADG 1 Manual De Instrucciones

English
Never store the battery in the analyzer.
4
Connecting Analyzer to
Power Supply
Mains voltage and operating voltage
must be the same.
3
Insert the mains plug (1) in the wall
N
outlet (2).
The following information is displayed
(shown with gray background):
Battery analyzer
ADG 1
A self test is performed after the unit is
connected to the power supply. During
this process the light emitting diode (3)
on the unit lights up green for about 1
second, then red and goes off again.
Self test
When self test is completed:
Insert the battery.
Insert the battery in the unit – see
N
"Testing battery".

Selecting Language

Connect the unit to the power
N
supply – mains voltage and
operating voltage of the unit must be
the same – see "Connecting Unit to
Power Supply".
2
1
Wait for unit to run self test – there is
N
no need to insert a battery in the unit
to select a language.
Press the button on the unit – see
N
"Main Parts" – for about 3 seconds
to activate language selection.
Press the button (about 1 second) to
N
select the required language.
To confirm the language selected,
N
press the button on the unit again
for about 3 seconds.
The language can be changed at any
time.
ADG 1