Updating Analyzer
The analyzer must be updated to cover
the latest cordless power tools or new
batteries and additional diagnostic
functions. The update can be performed
as described below.
Direct update with diagnostic software
and internet access
Computer with diagnostic software has
access to internet – see "Diagnostic
Software":
Connect analyzer to the computer
N
with the USB cable.
In the menu, click on button "Check for
updates... ". The diagnostic software
checks whether an update is available. If
yes, the update is performed
automatically.
Indirect update (without computer)
Data for updating the analyzer is
supplied by the subsidiary.
ADG 1
Testing the Battery
Connect the unit to the power
N
supply – see "Connecting to Power
Supply".
Operate the unit only in enclosed and
dry rooms at ambient temperatures
between 41°F (5°C) and 104°F (40°C).
Push the battery (1) into the unit (2)
N
until you feel noticeable resistance –
then push it as far as stop.
3
The test procedure begins as soon as
the light emitting diodes (3) on the
battery come on – see "Light Emitting
Diodes (LED) on Battery".
The following information is displayed
(shown with gray background):
Please wait ...
The battery and analyzer communicate
with each other. The analyzer can only
check the battery if this data exchange
functions. For this reason the battery
analyzer may only be used with
approved STIHL batteries. This
exchange of data may take several
minutes.
Identification of the battery is not
possible if data exchange between the
battery and analyzer fails.
Battery fault
Battery not recognized
2
Remove battery and insert it again.
N
If the same message appears again, the
battery is faulty and must be replaced.
Identification
SN: 981000602
Date of man.:
Meaning:
SN:
Model:
Date of man.:
For further information, hold the
N
push button (4) depressed for about
1 second.
English
Code: F 1
Model: AP 80
10-2008
Serial number
Battery type (e.g.
AP 80)
Month – Year
4
5