Packing The Chemical Protective Suit In A Cps Storage And Transportation Bag; Disposal; Withdrawal From Service; Service Life - Dräger CPS 7800 Instrucciones De Uso

Disposal

7.3.2 Packing the chemical protective suit in a CPS
storage and transportation bag
1. Place the chemical
protective suit in the CPS
storage and transportation
bag.
2. Fix the full face mask or
face cuff using the hook-
and-loop strap.
3. Place the protective boots
as illustrated.
4. Secure the chemical
protective suit below the
sleeves and on the boots
using straps.
5. Fold up the sleeves on the
shoulders and place on the
sides.
6. Close the CPS storage and
transportation bag.
7. Turn up the CPS storage
and transportation bag to
the middle on the tip of the
boots and directly under the
visor or on the neck, respectively.
8. Turn up the CPS storage and transportation bag in the
middle and close the strap buckles.
8 Disposal
8.1

Withdrawal from service

The chemical protective suit must be withdrawn from service in
the following situations:
It has been damaged and repair is not possible.

It was contaminated and cannot be decontaminated

anymore due to the characteristics of the hazardous
substance.
The material of the chemical protective suit has altered: it

shows embrittlement, swellings, colour changes, surface
maceration or similar.
In case of doubt please contact Dräger for more information.
8.2

Service life

The material properties of the chemical protective suit will be
maintained for at least 15 years
if not used and if stored under the recommended conditions,
with the recommended maintenance intervals. The service life
may be reduced despite correct storage and servicing if the
suit is used frequently.
8.3

Disposal instructions

The chemical protective suit must be disposed of in
accordance with the applicable regulations.
NOTICE
i
i
The chemical protective suits can be disposed of
thermally or on waste dumps. The type of disposal
depends on the contamination.
1 not part of the EU type approval test
34
1
from the date of manufacture
9

Technical data

9.1

General

Sizes in cm:
Height
Suit
measure
size
S 150-165
M 160-175
L 170-185 93-122
XL 180-195 96-124
XXL 190-205 99-130
Weight:
Size L, with
socks, glove combination,
face cuff
Size L, with
size 46/47 boots, glove
combination, face cuff
Material:
Chemical protective suit
Gloves
Safety boots
Socks
Colours:
Outside/inside
Temperatures:
During use
During storage
1 tested by Dräger
Chest Waist
measure
ment ment
82-112 68-100
92-118 72-110
77-112
77-113
78-118
approx. 3.50 kg
approx. 5.35 kg
D-mex
FKM or
FKM/butyl or
Laminate (HPPE) and Tricotril
(nitrile/para-amid) or
Laminate (HPPE) and butyl or
K-MEX-Gigant: Para-aramid or
Tricotril: Nitril/para-aramid
Nitrile-P
black, FPA-CR safety boots
D-mex
blue/grey
orange/grey
olive/grey
beige/grey
1
-40 °C to +70 °C
lower temperatures down to -80 °C
are possible on short-term
exposure and tested for the
material D-mex by Dräger, but not
as part of the EU type approval
test.
Observe operating temperatures of
the respiratory protective
equipment!
-30 °C to +60 °C
Dräger CPS 7800