Regulator And Lp Cylinder Connections - Cabela's CAB -36"-4B-GG Manual Del Usuario

REGULATOR AND LP CYLINDER CONNECTIONS

CAUTION
The gas pressure regulator provided with this griddle appliance
must be used.
• Your regulator is equipped with a GCC Type 1 quick connect system. It will not allow gas to flow until a positive seal
has been made. It has a thermal element that will shut off the flow of gas if the temperature reaches 115ºC (240ºF). It
also has a flow-limiting device that will restrict the flow of gas to 0.28 cubic meters per hour (10 cubic feet per hour).
• This regulator is set for an outlet pressure of 11 inch water column.
• Before each use, check the supply hose for excessive abrasion, wear, cuts, or leaks.
• If any damage is found, call Customer Service to obtain a replacement supply hose.
Hand
Wheel
Remove Dust Cap
TO CONNECT THE REGULATOR AND HOSE TO THE CYLINDER
1. Be sure the propane cylinder is OFF by turning the hand wheel clockwise until it stops.
2. Place the cylinder under the griddle body with the valve facing outward. (See Assembly
Instructions on p. 45 to see how to secure the cylinder to the griddle body.)
3. Remove the dust cap from the cylinder valve outlet.
4. Center the nipple of the regulator into the cylinder valve outlet.
5. Turn the black nut clockwise until it stops. Hand tighten ONLY. DO NOT use a wrench.
WARNING
Keep the LP cylinder in the upright position at all times.
Collar
Center the regulator nipple
in the cylinder valve outlet.
This regulator must enter the
cylinder valve in a straight line.
6
GCC Type 1 Connector
1-800-227-7776