Assembly - STOK QUATTRO SGP4033N Manual Del Operador

UNPACKING
This product requires assembly.
 Carefully lift grill from the carton and place it on a level
work surface.
NOTE: This grill is heavy. To avoid back injury, keep your
knees bent and lift with your legs, not your back, and get
help when needed.
WARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 Inspect the grill carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected the grill, identified all loose parts, and
satisfactorily operated the grill.
NOTE: Some loose parts are located inside the grill
assembly beneath the hood.
 If any parts are damaged or missing, please call
1-800-847-5993 for assistance.
WARNING:
If any parts are damaged or missing, do not operate
this grill until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
CAUTION:
Some parts may contain sharp edges that may cause
personal injury. Wear protective gloves if necessary.
STEP 1: INSTALLING THE CYLINDER
RETENTION BOLT AND CASTER ASSEMBLY
See Figure 5.
 Use a Phillips screwdriver to remove the screw at the end
of the cylinder retention bolt. Remove the washer.
 Insert the bolt through the hole and screw it into the nut
attached to the base. Turn the bolt clockwise until the
end comes through the nut.
 Reinstall the washer and the screw onto the bolt and
securely tighten the screw.

ASSEMBLY

BASE
Fig. 5
The right side of the base has a circular cut-out where the LP
gas tank will be placed. The two locking caster assemblies
should be installed on the right side of the base.
 Tilt the caster assembly so the hook on the underside of
the caster can be placed under the base.
 Keeping the hook under the base, tilt the back of the
caster assembly until the holes in the caster assembly
align with the holes in the base.
 Slide two bolts, M6 x 15 mm (EE), through the tab on the
rear of the caster assembly and into the base.
 Using hex lock nuts, M6 (HH), tighten caster assembly
securely to the base.
 Repeat for the other three caster assemblies.
 Set the base on a flat surface.
10 - English
CYLINDER
RETENTION BOLT/
WASHER/SCREW
HOLE
NUT
BOLTS
(EE)
HOOK
HEX LOCK
NUT (HH)
BASE
(W)
LOCKING
CASTER
ASSEMBLY