STOK QUATTRO SGP4033N Manual Del Operador página 12

STEP 5: MOUNTING THE FIREBOX TO THE
CABINET
See Figure 9.
NOTE: This step requires two people to lift and correctly
position the grill assembly on the cabinet.
 Locate the bracket at the bottom of the firebox and screw
in the front right corner of the cabinet. Loosen, but do
not remove, the screw.
 Lower the firebox assembly onto the cabinet, aligning
the holes in the firebox with the holes in the cabinet and
the loosened screw with the slot in the bracket.
NOTE: Regulator hose should be hanging down inside
the cabinet; be careful not to damage.
 Secure the firebox assembly to the cabinet by tightening
the screw onto the bracket in the front right corner and
installing bolts, M5 x 12 mm (FF), into the aligned holes
in the other three corners.
BRACKET
FIREBOX
ASSEMBLY
BOLT
(FF)
Fig. 9
ASSEMBLY
SCREW
REGULATOR
HOSE
REGULATOR
HOSE
12 - English
STEP 6: INSTALLING THE HOOD ONTO THE
FIREBOX
See Figure 10.
 To install the temperature gauge, remove the hex nut,
lock washer and washer.
 Insert the large threaded post through the large hole in
the hood and insert the small post into the small hole in
the hood.
TEMPERATURE GAUGE (V)
THREADED
POST
SMALL
HOLE
WASHER
LOCK WASHER
NUT
HOOD
LOCK WASHER
(BB)
FLAT
WASHER (CC)
HOOD BOLT
(DD)
Fig. 10
SMALL
POST
GRILL
HOOD
LARGE
HOLE
HOOD
NUT (AA)