Sears Kenmore Elite 796.2927 Serie Manual De Uso página 21

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I
I
CYCLE OPTION
BUTTONS
(cont.)
ADDA
GARMENT
[A_A
Garment_/ The ADD A GARMENT light will be
ch,mo
_v_! l ighted during the early portion of the
wash cycle to indicate that it is safe to
pause the cycle to add more items. It is not necessary to
press the button, as the light is controlled by the washer.
(See CHIME below.)
Once the ADD A GARMENT light goes out, additional
laundry should not be added to the load. Doing so may
result in unsatisfactory performance because the washer
will not compensate for the additional garments.
O
Press the START/PAUSE button to pause the washer.
_t
Open the lid after it unlocks.
O
Add your additional items.
_t
Close the lid.
_t
Press the START/PAUSE button. The cycle will
resume after the lid locks.
CHIME
IAdd A Garment_ The volume of the chime is adjusted
Ch_mo
_ using the ADD A GARMENT button.
Press the button to change the vol-
ume of the chime. The chime will sound at the new vol-
ume with each press of the button. When no chime is
heard, the chime is off. The volume settings are
LOW - HIGH - OFF.
MY CYCLE
I
My Cycle
MY CYCLE allows you to store a CUS-
PGMSave
tomized wash cycle for future use. It
allows you to save favorite tempera-
ture, spin speed, soil level, and other options for a cycle,
and then recall them at the touch of a button.
NOTE: You may only save setting for one cycle at a time.
Pressing and holding the MY CYCLE button will overwrite
any previously saved my cycle.
To
0
0
0
0
0
save a my cycle:
Press the POWER button to turn on the washer.
Turn the Cycle Selector Knob to select the desired cycle.
Press the Cycle Modifier button to change the desired
setting.
Press the Cycle Option button to add the desired
options.
Press and hold the MY CYCLE button.
21
To recall a my cycle:
Press the POWER button to turn on the washer.
Press the MY CYCLE button. The stored settings will
be displayed.
O
Press the START/PAUSE button to start the cycle.
NOTE: MY CYCLE can be adjusted the same as any
other cycle. However, once any other button is pressed
the LED will be turned off indicating that the settings are
no longer those of your saved cycle.
FABRIC SOFTENER
_] Fabric softener is dispensed in the
FabricSoftener
final rinse. Select FABRIC SOFTENER
button to change final rinse from spray
rinse to deep rinse.
NOTE: The NORMAL/CASUAL
cycle and the HEAVY
DUTY cycle use a special JET SPRAY rinse to save
water. If fabric softener is to be used with either of these
cycles, then the FABRIC SOFTENER option or the
EXTRA RINSE option must be selected. Either option will
cause the cycle to end with a deep rinse instead of the
spray rinse. All though the softener will be dispensed, fail-
ure to select either option will result in poor fabric soften-
er performance.
SOAK
Use the SOAK option to presoak gar-
Soak
ments to help remove difficult spots or
stains on fabrics. This option provid
180 minutes (maximum) presoak prior to the start of the
selected cycle. At the end of the soak time, the selected
cycle will begin using the water already in the tub.
I
I

Publicidad

Tabla de contenido
loading

Tabla de contenido