Special Safety Feature - Sears Kenmore Elite 796.2927 Serie Manual De Uso

I I
CYCLE OPTION BUTTONS (cont.)
DELAY WASH
Once you have selected the cycle and
Delay Wash other settings, press this button to
delay the start of the wash cycle. Each
press of the button increases the delay time, for up to 19
hours. Once the desired delay time is set, press the
START/PAUSE button to start the delay time.
NOTE: If the START/PAUSE button is not pressed to
begin the delay time, the washer will automatically shut
off after 4 minutes.
DRAIN & SPIN
Drain & Spin _ Use this option to drain the water from
Co,,,_o_Loc, _1 the tub and spin out the clothes. This
can be used, for example, if the wash
cycle were interrupted by a power failure. Spin speed can
be adjusted by pressing the SPIN SPEED button.
_1 Press the START/PAUSE button to turn on the washer.
Press the DRAIN & SPIN button.
Press the SPIN SPEED button to select the desired
spin speed.
Press the START/PAUSE button.
CONTROL LOCK
Drain & Spin ]1 Use this option to prevent unwanted use
Coot_o_ ,o_, of the washer or to keep cycle settings
from being changed while the washer is
operating. Press and hold the DRAIN & SPIN button for 5
seconds to activate or deactivate CONTROL LOCK.
Once CONTROL LOCK is selected, the display will
alternate between CL and the remaining cycle time. And all
controls except CONTROL LOCK and POWER buttons will
be disabled.
NOTE: The controls remain locked even after the cycle
ends or if there is a power failure. To deactivate CONTROL
LOCK, press the POWER button to turn the washer on,
then press and hold the DRAIN & SPIN button for
5 seconds.
SPECIAL SAFETY FEATURE
This washer is equipped with a special feature that is designed to make your washer as safe as possible. If the washer
is paused or shut off while there is still water in the tub, the washer will automatically drain the water after 4 minutes to
help keep children safe by reducing the possibility of water remaining in the tub.
If the washer is shut off for three minutes while there is still water in the tub, an alarm will sound to notify you that the
washer is about to drain the water from the tub. The washer can be restarted at this time if desired.
If the washer is paused for 4 minutes, the display will go off and all cycle settings will be lost. After three more minutes,
the alarm will sound to notify you that the washer is about to drain the water from the tub. The washer can be turned on
and another cycle started if desired.
If no action is taken, the "dr" error code will be displayed and the water will be drained from the tub. Once the washer
begins draining the water, the controls are disabled and the drain process cannot be interrupted. Once the water is
completely drained, the washer will shut off.
NOTE: In the unlikely event that the washer experiences an error that causes an error code to be displayed, the washer
will still sound the alarm after three minutes and drain after 4 minutes. However, only the original error code will be dis-
played.
22
I I