Fein AGSZ18-280BL Manual De Instrucciones página 24

OBJ_BUCH-0000000285-001.book Page 24 Monday, February 19, 2018 10:27 AM
en
24
the power tool and the materials being sanded, empty the
dust collector/container in time, observe the material
manufacturer's working instructions, as well as the rele-
vant regulations in your country for the materials being
worked.
Operating Instructions.
The self-start lock prevents the cordless straight grinder
from automatically restarting again after a power inter-
ruption, e.g., after changing the battery. In this case,
switch the power tool off, remove it from the workpiece
and check the application tool. Afterwards, switch the
power tool on again.
Use a collet that fits the grinding accessory.
Insert the clamping shaft of the grinding accessory to the
stop into the collet chuck.
Observe the maximum permitted projecting shaft length
(a) of the grinding accessory according to the manufac-
turer's instructions (see page 7).
Move the power tool back and forth applying uniform
pressure, so that the workpiece surface does not become
too hot.
For best performance, operate the power tool only with
the B18A.173 battery. When using other batteries, the
functionality can be limited.
Handling the battery.
Operate and charge the battery only within the battery
operating-temperature range of 0°C – 45°C (32°F –
113°F). At the beginning of the charging procedure, the
battery temperature must be within the battery operat-
ing-temperature range.
LED indica- Meaning
tor
1 – 4 green Percentage of
LED charge condi-
tion
Continu- Battery is
ous red almost empty
light
Red flash- Battery is not
ing light ready for
operation
The real percentage of the battery charge condition is
only indicated when the power tool motor is stopped.
The electronics automatically switch off the motor prior
to the battery being deep discharged.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool. Blow out
the interior of the power tool via the ventilation slots fre-
quently with dry and oil-free compressed air.
When working gypsum-containing materials, dust can
settle within the power tool and switch element, which
can harden in connection with humidity. This can impair
the switching mechanism. Blow out the interior of the
power tool via the ventilation slots and the switch ele-
ment frequently with dry and oil-free compressed air.
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available through
the FEIN customer service centre.
TThe current spares parts list for this power tool can be
found on our website at www.fein.com.
If required, you can change the following parts yourself:
Application tools, collet
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
Instruction Manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-D1_IA,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.
Activity
Dispose of batteries only when discharged.
For batteries that are not completely discharged, insulate
Operation
the terminals with tape as a protective measure against
short-circuiting.
Selection of accessories (see page 7).
Charge battery
Use only original FEIN accessories. The accessories must
be intended for the power tool type.
Bring the battery into
A Collet
the battery operating-
temperature range, then
charge