Makita XKH01 Manual De Instrucciones página 6

Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Overload protection
When the battery is operated in a manner that causes
it to draw an abnormally high current, the tool automat-
ically stops without any indication. In this situation, turn
the tool off and stop the application that caused the tool
to become overloaded. Then turn the tool on to restart.
Overheat protection
When the tool or battery is overheated, the tool stops
automatically. In this case, let the tool and battery cool
before turning the tool on again.
NOTE: When the tool is overheated, the lamp blinks.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
When not operating the tool,
depress the trigger-lock button from
lock the switch trigger in the OFF position.
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided. To start the tool,
depress the trigger-lock button from A (
the switch trigger. Tool speed is increased by increas-
ing pressure on the switch trigger. Release the switch
trigger to stop. After use, depress the trigger-lock button
from B ( ) side.
B
► 1. Trigger-lock button 2. Switch trigger
side to
) side and pull
1
2
Using the trigger-lock button for
continuous operation
For continuous operation, depress the trigger-lock button from B ( )
side while pulling the switch trigger, and then release the switch trig-
ger. To stop the tool, depress the trigger-lock button from A (
B
► 1. Trigger-lock button 2. Switch trigger
Speed adjusting dial
► 1. Speed adjusting dial
The blows per minute can be changed by turning the speed adjusting
dial to a given number setting from 1 to 5. Higher speed is obtained
when the dial is turned in the direction of number 5. And lower speed
is obtained when it is turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the blows per minute.
Number
1
2
3
4
A
5
CAUTION:
the tool is running. Failure to do so may result in
the loss of control of the tool and cause an injury.
NOTICE:
The speed adjusting dial can be turned
only as far as 5 and back to 1. Do not force it past
5 or 1, or the speed adjusting function may no
longer work.
6 ENGLISH
1
2
Blows per minute
1,000/min
1,300/min
1,900/min
2,700/min
3,200/min
Do not turn the adjusting dial when
) side.
A
1