Safety Note; Scope Of Delivery - Benning MM 11 Instrucciones De Servicio

2.

Safety note

The instrument is built and tested in accordance with
DIN VDE 0411 part 1/ EN 61010-1
and has left the factory in perfectly safe technical state.
To maintain this state and ensure safe operation of the appliance tester, the user
must observe the notes and warnings given in these instructions at all times.
The unit may be used only in power circuits within the
overvoltage category III with a conductor for 600 V max. to
earth, or within overvoltage category II with a conductor for

000 V against ground.
Remember that work on electrical components of all kinds is
dangerous. Even low voltages of 30 V AC and 60 V DC may be
dangerous to human life.
Before starting the appliance tester up, always check it as well

as all cables and wires for signs of damage.
Should it appear that safe operation of the appliance tester is no longer possible,
it should be shut down immediately and secured to prevent it being switched
on accidentally.
It may be assumed that safe operation is no longer possible:
- if the instrument or the measuring cables show visible signs of damage, or
- if the appliance tester no longer functions, or
- after long periods of storage under unfavourable conditions, or
- after being subjected to rough transport.
In order to avoid danger,
- do not touch the bare prod tips of the measuring cables

- insert the measurement lines in the appropriately
designated measuring sockets on the multimeter
3.

Scope of delivery

The scope of delivery for the BENNING MM 11 comprises:
3.1 one BENNING MM 11
3.2 one software BENNING PC-Win MM 11
3.3 one serial data cable with USB 2.0 compatible connection
3.4 one safety measuring cable, red (L = 1.4 m; prod tip diameter = 4 mm)
3.5 one safety measuring cable, black (L=1.4 m; prod tip diameter = 4 mm)
3.6 one wire temperature sensor type K,
3.7 one adapter for wire temperature sensor,
3.8 one rubber protection frame,
3.9 one magnetic holder with adapter and strap
3.10 one compact protective pouch,
3.11 a 9 V block battery and two different fuses (fitted in unit as first equipment),
3.12 one operating instructions manual
Note on optional accessory:
- Temperature probe (K-type) made of V4A tube (P.no 044121)
application: insertion probe for soft-plastic materials, liquids, gas and air
measuring range: - 196 °C up to 800 °C
dimensions: length = 210 mm, tube length = 120 mm, tube diameter =
3 mm, V4A
Parts subject to wear:
- The BENNING MM 11 contains fuses as protection against overload:
One fuse, rated current 1 A quick-acting (600 V), 10 kA, D = 10 mm, L = 35
mm (P.no 749598) and one fuse, rated current 15 A quick-acting (600 V),
100 kA, D = 10 mm, L = 38 mm (P.no 749595).
- The BENNING MM 11 is supplied by a fitted 9 V block battery (IEC 6 LR 61).
- The above-mentioned safety measuring cables ATL-2 (tested accessories,
P.no 044118) correspond to CAT III 1000 V and are approved for a current
of 10 A.
4. Description of appliance tester
See figure 1:
The display and operator control elements specified in Fig. 1 are designated
as follows:
 Digital display, for the measurement value, bar graph display, overranging
display
09/ 2007
Appliance front face
­ B ENNING­MM­11­

7