STERWINS 20VLM2-33P.1 Instrucciones De Montaje página 299

FR
Problems
ES
PT
IT
Product does
not start
EL
PL
RU
The handle is
KZ
not correctly
fi tted
UA
The mower cuts
RO
unevenly
BR
Mulching is not
done correctly
EN
The mower is
diffi cult to push
The grass
cuttings are
not collected
properly in the
grass box
The mower
vibrates at high
speed
The motor stops
while mowing
Probable causes
Battery is not secure
Battery is not charged
Power/speed switch is in the
OFF position
Battery pack not properly
attached
On/off switch not set on ON
position
The panel bolts are not
correctly inserted
The quick-fastening levers
are not tightened
The grass is not uniform or
thick, or the cutting height
was not correctly adjusted
The grass cuttings are damp
and sticking to the mower
The grass is long, the rear
panel of the mower and the
blade are dragging in very
dense grass, or the cutting
height is set too low
The cutting height is too
low
The blade is out of balance
or worn
The motor shaft is twisted
The cutting height is too
low
The battery is discharged
Solutions
To secure the battery pack,
make sure the latches on the
top of the battery pack snap
into place
Charge the battery pack
according to the instructions
included with your model
Press the on/off switch
Attach properly
Refer to chapter "Start the
product"
Adjust the height of the handle
and check that the panel bolts
are correctly inserted
Tighten them
Check the height of the wheels.
All the wheels must be set to
the same cutting height so that
the mower can cut evenly
Wait for the lawn to dry before
mowing
Raise the cutting height
Raise the cutting height
Change the blade
Turn off the motor and inspect
the mower. Get the mower
repaired.
Raise the cutting height
Recharge the battery
300
Qualifi cation
required
-
-
-
-
-
-
-
Approved repair
centre
-