Mr Coffee DMX Serie Manual Del Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Decalcify The Hot Shot
lime deposit may accumulate in the Hot Shot
causing longer heating cycles.
The rate at which the deposit forms will vary depending on
the hardness of the water used and the frequency
with which the unit is used. To remove the deposit:
1. Unplug cord from outlet.
2. Add a mixture of 1/2 water and 1/2 white distilled
vinegar solution (8 fluid oz. – 235 ml each) to the
heating chamber and let it remain in the heating
chamber until the deposit is removed. Drain the cleaning
pressing the lever down and sliding to the left to
dispense. DO NOT HEAT THE VINEGAR SOLUTION.
3. Run one or two fresh water cycles to remove any
residual cleaning solution.
Water Filtration Disk Replacement
Your water filtration disk will need to be replaced once a
month (approx. 30 brew cycles). If the machine will not be
in use for an extended period of time, rinse the water filter
with running water and clean the coffeemaker before use.
20
BVMC-DMX85_15ESM1.indd 21-22
Station
After continual use, a
TM
Station
Cleaning the Decanter
Hard water can leave a whitish stain on the decanter, and
TM
coffee may then turn this stain brown.
To remove decanter stains:
1. Fill the decanter with a solution of equal parts water
and vinegar and let the solution stand in the decanter
for approximately 20 minutes.
2. Discard the solution, then wash and rinse the decanter.
Do not use harsh abrasive cleaners that may scratch the
decanter, scratches may cause the decanter to break.
Suggested Decalcifying Interval
Type of Water
Soft Water
Hard Water
Cleaning Frequency
Every 80 Brew Cycles
Every 40 Brew Cycles
or when red light is flashing
21
3/3/15 9:11 AM

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido