Setting The Clock And Delay Brew Time; Preparing For Use; Using The Hot Shot - Mr Coffee DMX Serie Manual Del Usuario

Water level should always be lower than the black plastic
edge in the heater. Close the lid and press the ON button
on the front of the unit. NOTE: The white light will pulse
while the water is heating and will remain lit when the
water is ready to dispense. When heating is complete
dispense all of the water(16oz) and discard.
Once the system flush is complete, your appliance is ready to
brew and heat water.

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on the
control panel to indicate that the time has
not been set yet.
2. Press and hold the Hour button until you
reach the current time and then press and
hold the Minute button to reach the current
minute time. The AM or PM indicator will
light on the display (Figures 1 and 2). The
clock is now set
NOTE: Pressing any button before setting the
clock will cause the clock to start keeping time
from 12:00 a.m. You must set the clock if you
want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply
press the SET DELAY button (Figure 3) and,
while the DELAY BREW time is flashing, set the
brew time by pressing the Hour and Minute
buttons. The AM or PM indicator will light at the
top of the clock display. (Figure 4)
Within a few seconds the display will change to the current time.
The Delay Brew Time is now set!
10
BVMC-DMX85_15ESM1.indd 11-12
NOTE: To activate the DELAY BREW cycle, see
the "Brewing Coffee Later" section.
To check the programmed time, push the SET
DELAY button. The display will show the time
you have programmed the coffee to brew. If
you press the SET DELAY button again or wait a
few seconds, the display will switch back.

PREPARING FOR USE

Using the Hot Shot

1. Refer to Cleaning Your Appliance before the first use.
2. Use the Hot Shot Station
ATTEMPT TO HEAT ANY OTHER LIQUID OR
FOOD IN THIS UNIT.
Figure 1
3. Open the lid and pour the amount of
water you wish to heat and use up
immediately (up to 16 fluid ounces –
475 ml.) into the heating chamber.
DO NOT OVERFILL HEATING CHAMBER.
DO NOT USE MORE THAN 16 FL.
OZ.(475 ml). Water level should always
be lower than the black plastic edge in
Figure 2
the heater. (Figure 5)
4. Close the lid and press the ON button
on the front of the unit. (Figure 6)
NOTE: The white light will pulse while
heating and stays on while water is hot
and ready to dispense.
5. Add desired ingredients to your cup
or bowl and center on the base
underneath the dispensing spout. Push
Figure 3
the lever to the left while pressing
down to fill the cup or bowl.
6. When you are ready to dispense. Push
Figure 4
Station
TM
to HEAT WATER ONLY. DO NOT
TM
Figure 5
Figure 6
11
3/3/15 9:11 AM