Driving Treads - ECOVACS WINBOT 7 Manual De Instrucciones

Edge Detection Sensors
Turn the robot over and remove the Cleaning
Pads. Wipe the Edge Detection Sensors
clean with the provided Finishing Cloth to
maintain their effectiveness. (W730 ONLY)

4.3 Driving Treads

Move the Power Switch on WINBOT 7 to the
CHARGE position.
4. Maintenance
Squeegee
Turn the robot over and wipe the Squeegee
clean with the provided Finishing Cloth to
maintain its effectiveness.
Turn WINBOT 7 over. Inspect the Driving
Treads by using the
Remote Control. Stop the Driving Treads if
dirt is seen on the Treads.
Move the Power Switch on WINBOT 7 to the
OFF position.
Clean any dirt on the Driving Treads with the
provided Finishing Cloth.
and buttons on the
EN
13 13