Preparing And Connecting The Foam Cover; Cleaning And Care - Ottobock 1C10 Terion Instrucciones De Uso

• Remove the adapter cover from the prosthetic foot after completion of
the dynamic trial fitting and gait training exercises.

5.2 Preparing and connecting the foam cover

The connection cap serves as a detachable connection between the cosmet­
ic foam cover and footshell, and snaps precisely into the proximal brim of the
footshell.
Required materials and tools: 634A58 Isopropyl Alcohol, 636N9 Con­
>
tact Adhesive or 636W17 Plastic Adhesive
1) Cut the foam cover to length according to the patient's measurements,
allowing for distal compression of about 1 cm for transtibial and of about
4 cm for transfemoral covers.
2) Pull the foam cover over the prosthesis.
3) Join the connection cap to the footshell and mount the prosthetic foot.
4) Mark the outer contours of the connection cap on the distal face of the
foam cover blank.
5) Dismount the prosthetic foot and remove the connection cap from the
footshell.
6) Clean the connection cap with isopropyl alcohol.
7) Glue the connection cap to the face of the foam cover as marked and
allow the glued joint to set (approx. 10 minutes).
8) Mount the prosthetic foot and adapt the exterior cosmetic cover shape.
Take into account compression due to cosmetic stockings or SuperSkin.

6 Cleaning and Care

1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
► The prosthetic components should be inspected after the first 30 days of
use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
8 Disposal
This product may not be disposed of with regular domestic waste in all juris­
dictions. Disposal that is not in accordance with the regulations of the coun­
try where the product is used may have a detrimental impact on health and
the environment. Please observe the information provided by the responsible
Ottobock | 17