Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Accessories
The following components are not included in the scope of delivery and may be ordered separ
ately:
•
4X78 charger extension cable
•
1 4X350 remote control
•
1 pc. 757P48 Y adapter cable
Adapter cable for simultaneous charging of the product and a mechatronic knee joint (e.g.
3B1/3B1=ST; 3B5-X3/3B5-X3=ST; 3C98-2/3C88-2; 3C96-1/3C86-1) with 757L16* power
supply.
6 Charging the battery
The following points must be observed when charging the battery:
•
The capacity of a fully charged battery is sufficient for one full day.
•
We recommend charging the product overnight when used by the patient on a daily basis.
•
When used daily, the complete charging unit (power supply – battery charger) may remain
plugged into the wall socket.
•
The battery should be charged for at least 3 hours prior to initial use.
•
Use the 757L16* power supply and 4E50* battery charger to charge the battery.
•
The ankle joint of the prosthetic foot is locked during the charging process.
6.1 Connecting the power supply and battery charger
1) Slide the country-specific plug adapter onto the power supply until it locks into place.
2) Connect the round, three-pin plug of the power supply to the 12V receptacle on the battery
charger so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger
light up.
→ If the green LED on the power supply and the green LED on the battery charger do not light
up, there is an error (see Page 67).
46 | Ottobock
Publicidad
Tabla de contenido
