Reading The Set Date; Measuring Procedure - Microlife 3AA1-1 Instrucciones De Uso

9. Press the User/Time button again. The last two
characters (Minutes) now blink.
10. The minutes can now be entered by pressing the
MEMORY button. (Example: 30 x presses
advances the time from 0 to 30 minutes)

5.5. Reading the set date

After all settings have been made, click the User/Time
button once. The date is briefly displayed and then the
time. The input is now confirmed and the clock begins
to run.

5.6. Measuring procedure

After the cuff has been appropriately positioned
the measurement can begin:
a) Press the ON/OFF/START button. The pump
begins to inflate the cuff. In the display, the
increasing cuff pressure is continually displayed.
b) After automatically reaching an individual
pressure, the pump stops and the pressure
slowly falls. The cuff pressure is displayed during
the measurement.
c) When the device has detected your pulse, the
heart symbol in the display begins to blink and a
beep tone is audible for every pulse beat.
d) When the measurement has been concluded, a
long beep tone sounds. The measured systolic
and diastolic blood pressure values, as well as
the pulse are now displayed.
e) The measurement results are displayed until you
switch the device off. If no button is pressed for 5
minutes, the device switches off automatically.
11
Pumping
Pressure
Measuring
Systolic
Measurement
Diastolic
complete
Pulse