End Of Product Life; Troubleshooting - Sunoptic Surgical Titan 300 Manual Del Operador

normal wear and tear or if transferred to a new owner without authorization from SUNOPTIC
®
TECHNOLOGIES
other rights that vary from state to state.
POST WARRANTY REPAIRS: You may return your product(s) for repair, shipping prepaid
to the factory. Your product will be inspected and an estimate of repair charges will be
submitted to you for approval.
In the US call:
•
FAX number:
•
9.

END OF PRODUCT LIFE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to
manufacturer at the end of product life.
10.

TROUBLESHOOTING

Problem
The power indicator (refer to
4.1) is not lit.
The power indicator is lit, but
Xenon lamp will not ignite.
LIT125
SUNOPTIC SURGICAL
(English)
. This warranty gives you specific legal rights and you may also have
Solution
A. Check that the AC power cord is properly connected.
B. Check the circuit breakers. If necessary, reset.
C. Power input switch is in the off position
A. Check to make sure lamp cartridge is seated properly.
B. Check that the lamp door is secured.
C. Check hour meter; if lamp hours exceed the rated lamp life,
replace the lamp (refer to 8.1).
®
877 677-2832 (toll free)
904 733-4832
Date of Revision: 03/28/17
Rev. H
Page 11 of 72