Operation; Powering Up Light Source; Lamp Life Hours Display; Cleaning And Disinfection - Sunoptic Surgical Titan 300 Manual Del Operador

6. OPERATION

6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the light source to the instrument or headlamp.
Turn on the rear power switch. Turn on the lamp switch The fan will start. The indicator on
lamp switch will light.
6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL
The light brightness adjustment enables the user to obtain a brighter or darker illumination
of the object of observation.
Adjust the light intensity by turning the intensity control knob.

6.3 LAMP LIFE HOURS DISPLAY

The hour meter on the rear of the illuminator shows the total elapsed running time of the
unit. When the lamp is replaced, reset the hour meter to track total lamp usage hours on
the replacement lamp.

7. CLEANING AND DISINFECTION

NOTE Always disconnect the power cord before cleaning and while unit is
drying if wet-wiped.
NOTE: Always disconnect the power cord before cleaning and while unit is drying if wet-wiped.
Cleaning and disinfection agents should be commercially available cleansers commonly used
for cleaning and/or disinfection of electronic equipment cabinets in hospitals, such as ethyl or
isopropyl alcohols, disinfecting sprays containing quaternary ammonium compounds or
hydrogen peroxide.
Do not use strongly caustic or acidic cleaners such as "Clorox" hypochlorite bleach, ammonia,
muriatic acid or similar products. Do not use acetone, methyl ethyl ketones or halogenated/
chlorinated hydrocarbon solvents, or cleaners containing any of these restricted compounds.
Apply cleaning agents by light spray or dampened towels. Do not pour liquids over the cabinet.
Do not allow liquids to enter the cabinet seams or ventilation openings, or remain within switch
or control device crevices
8. MAINTENANCE, SERVICING AND REPAIR, WARRANTY
Performance of preventive maintenance is not essential. Regular maintenance can, however,
contribute to identifying potential problems before they become serious; thus, enhancing the
instrument's reliability and extending its useful operating life. Maintenance services can be
obtained from your local representative or from the manufacturer.
Defective items of equipment are to be serviced and repaired exclusively by persons authorized
by the manufacturer. All repair work shall employ original manufacturer's parts only.
LIT125
SUNOPTIC SURGICAL
(English)
®
Rev. H
Date of Revision: 03/28/17
Page 9 of 72