Parker AC30 Serie Manual Del Producto página 326

D-34
Parameter Reference
Parameter Name No.
Clone Status 1543
This parameter indicates the status of the cloning process.
Enumerated Value : Power Parameters
0 : IDLE
1: SAVING
2 : RESTORING
3 : VERIFYING
4 : DONE
5 : CANNOT START
6 : FAILED
7 : NO SD CARD
8 :RS FAILURE
Notes:
1) The clone file only contains the parameters that were stored in non-volatile memory on the drive when a clone save was
performed. When performing a clone load and a full restore is performed or a LOAD FROM FILE is used for the parameters,
then any parameter not previously saved in the file will be set to its defaults.
2) Each application parameter is restored only if the parameter definition on the target drive matches the saved parameter.
3) The clone saving process will take between 3 – 15 seconds depending on the type of SD card used.
4) When saving a file with the same filename as an existing file on the SD card, the existing file will be overwritten. To prevent
this, use a PC to set the read-only attribute of the file.
5) During the clone loading process the GKP screen may blank momentarily.
Path
Same as PNO 1534
- waiting for the user to start the cloning process.
- in the process of saving the drive configuration to file.
- in the process of loading the configuration from file.
- in the process of verifying the clone file either before a load or after a save.
- the cloning process has completed successfully either for a load or a save.
- the cloning process cannot start. When restoring a configuration the drive must be stopped.
- general failure of the cloning process.
- no SD card is fitted.
- could not restore the parameters. E.g. the parameters are missing from the clone file.
Default Range
0:IDLE
1:SAVING
2:RESTORING
3:VERIFYING
4:DONE
5:CANNOT START
6:FAILED
7:NO SD CARD
8:VERIFY FAILED
9:FILE NOT OPENED
10:FILE INCOMPATIBLE
11:FILE FAILURE
12:POWER MISMATCH
13:APPLICATION FAILURE
14:PARAMETERS FAILURE
Units Writable
NEVER
AC30 series Variable Speed Drive