Louisiana Grills Champion Serie Instrucciones Y Uso página 10

• Using two (2) Phillips screws (D), washers (G) and spring washers (F) secure the handle to hopper access panel, just above the
fan intake, through the two (2) large holes provided.
• Begin by hand starting the threads, then use your Phillips screwdriver to secure.
Step 2 - Preparing for the Hopper:
Place six (6) Multi-head screws (E), washers (G) and spring washers (F) into the main barrel cavity to aid in installing the hopper.
Step 3 - Attaching the Grill Probe Wires:
Your Grill/Smoker comes complete with the "Digital Control Center"
complete with grill probe and programmable meat probe. The grill probe
has been factory installed in the cabinet, with the excess wire and connections
run out through the left end. Be careful not to kink or damage the wires.
The wire connections to the control board can be found inside or taped to the
outside of the hopper. Diagram C
To connect the spade connections, carefully lift the entire hopper to the left
hand-side of the upper cooking cabinet.
IMPORTANT: Ensure the probe wires are run only through this large hole
in the hopper as shown in diagram C.
Begin by resting the bottom of the hopper on the ledge of the burn pot,
sticking out past the barrel. Support the hopper on your leg as you connect
the two spade connections. Diagram D
After firmly connecting the spade connections, carefully thread ALL excess wire,
as well as the connections, back into the hopper. The wiring must not come in
contact with either the fan blades, or the metal auger tube.
IMPORTANT: All excess wire and connections must be placed back in the
hopper. Ensure that they DO NOT touch the fan.
Step 4 - Attaching the Hopper to the Barrel:
• Carefully lift the entire hopper, with the attached grill probe wires, off the
lip of the burn pot.
• Begin by slightly inserting the Auger Feed tube into the auger hole. Then
raise the hopper, as the mounting bracket on the rear of the hopper must be
raised slightly higher than the receiving bracket on the barrel.
• Push the top of the hopper tightly against the main barrel, inserting the auger
tube fully into the barrel. Holding the hopper fairly level, press downward, to
clip the hopper onto the mounting bracket.
• Holding the hopper in place, use one (1) of the Multi-head screws (E), along
with the spring washer (F) and washer (G) from the six (6) you put in the cavity, and
begin hand threading it into one (1) of the six (6) holes provided in the main
barrel cavity.
NOTE: If the holes do not line up, the hopper may need to be fully pushed down into place.
10
C
D