Slopes; Transport And Unloading; Important; Technical Features - Gianni Ferrari PG 200 Serie Manual Tecnico

6.1 SLOPES

See figure 6.1
- Do not use the machine on longitudinali slopes of more than 15°.
- Do not use the machine on lateral slopes higher of more than 12°.
- Do not proceed on slopes of any kind (lateral or longitudinal) with the plate lifted.
- Do not stop or start suddenly the machine when going up or down a slope.
- Proceed with low speed on slopes or narrow curves.
- Pay attention to any road humps, potholes or other hidden dangers. If the ground is irregular,
the machine can overturn more easily.
- Do not operate in the proximity of shoulders, ditches or river banks; the machine could suddenly overturn if a
wheel goes beyond the edge of the latter, or if the shoulder cedes.

Important!!!

Counterweights fitting may be required by the attachment manual of the interchangeable attachment.

6.2 TRANSPORT AND UNLOADING

The machine is heay and can cause serious crushing damages.
Load and unload it with care and use loading ramps.
Transport the machine on a homologated trailer. During transport, use the the parking brake and fix the machine
with homologated devices, such as belts, chains or ropes.
N.B.: If the machine is packed and mounted on its pallet, it is possible to move it with a forklift.
CAPACITY 1200 Kg
IMPORTANT:
The parking brake is not sufficient for locking the machine during transport. Fix appropriately
the machine to the vehicle with homologated devices.

7. TECHNICAL FEATURES

Measurement in mm.
The measurements shown also apply for "SR" models.
✱✱
See technical manual for the equipment
Engine
Engine power
Displacement (cc.)
N° of cylinders
RPM
Driving wheels
Type of progress
Service brake
Parking brake
Max speed (Km/h)
Fuel tank (L)
✱
Basket capacity (L)
Max container capacity(Kg)
✱
Only "PG" models
See figure 6.2
See figure 7.
PG/SR 280D
KUBOTA
D 1105
29.1
1.123
3
3000
Front with possibility of differential locking
13,7
Only "SR" models
PG/SR 220D PG 230
KUBOTA
D 902
22
898
3
3200
Hydrostatic
Hydrostatic
Mechanical disk
11
30
800
80
EN
B&S
23 HP
23
627
2
3600
27