Electrical Connection; Putting Into Operation - ROTOR Vitamat Inox RVI Manual De Instrucciones

Instruction Manual
Grossküchen- und Bäckereimaschinen
Rotor Vitamat INOX
CH-3661 Uetendorf
© Rotor Lips AG

5. ELECTRICAL CONNECTION

The power supply voltage must correspond to the values on the
rating plate on the appliance (the voltage rating is given in volts [V]
and fullfill the requirements listed in chapter „Technical data".
The appliance should only be connected to a single phase grounded
alternating current. Make sure that the original mains cable and
the wall outlet correspond.
For safety reasons the outlet must have a faulty-energy-protection switch (FI).
If at all possible, avoid using an extension cord. If it is unavoidable, only proper, approved
extension cords should be used.
Do not subject the mains cable to strong tension or pressure.
To replace the cable, see chapter „Repairs".

6. PUTTING INTO OPERATION

Before using the appliance for the first time it must be thoroughly cleaned. Follow the
instructions in Chapter „Cleaning".
Place the correctly mounted juice extractor Vitamat INOX on a firm, flat base. Make
sure by organisational or technical means, no fluids can gather underneath the machine
(hygiene, electrical security). Plug it into a nearby, appropriate electrical outlet.
The pulp can be output different ways:
- directly into the container (only use the original type!).
- marc pipe through bar (optional accessory).
17