Seating Installation - Sunrise Medical Zippie VOYAGE Manual De Instrucciones

Z IPP IE VO YA GE
I. SEATING INSTALLATION
BEFORE installing the seating shell, always check that the mobility device is completely
unfolded and in the locked position, and that all four wheels are locked in place. The seating
shell should never be installed with a seated occupant. Always remember to stabilize the
mobility device before performing this action.
• Rotate the front casters until they point forward.
• Engage the parking brake.
The seating shell has a latch mounted underneath the seat plate. The interface on the base
is the counterpart to the latch and mates with the latch. The seating shell may be installed
so that the child can face either frontwards or rearwards. Installation is the same in either
direction.
Rotating the seat shell direction
a. Lock the wheels, remove the seat.
b. Be sure the Tilt setting is at the "home" or 0° position. Do this by squeezing the
Tilt Release lever and letting the "Slide-n-Lock" (Receiver) Plate spring flat.
c. STEP 1: Press the Gold Button, Numbered 1 (A) on the Slide-n-Lock plate and
rotate the plate until it stops (Fig 15).
d. STEP 2: Pull the Pin (B) with one hand and rotate the Tilt Limiter Sleeve (C) with
your other hand* (Fig 16a & b).
-NOTE: Only rotate the Tilt Limiter Sleeve in the process of Rotating the Plate.
*When the seat is forward facing the Tilt Limiter Sleeve should be rotated
Rearward, when the seat is rearward facing the Sleeve should be rotated Forward.
e. STEP 3: Finish rotating the Plate 180° until it locks into place (Fig 17).
Install the seating shell
NOTE - When installing the Moderate Seating System in the rearward facing direction, raise the
footrest to about a 5 degree angle, to clear the stroller base crossbar and allow seat to lock
into the receiver.
a. Make sure the seat is in the fully upright position (no recline or tilt).
b. Ensure all positioning straps and accessories are out of the way and will not interfere
with the seat from fully engaging the receiver.
c. Line up the alignment tag (D) with the support cross bar (E) on the base (Fig 18).
d. Lower the seating shell so that the seating shell and mounting plate are in
contact.
e. Slide the seat backwards evenly. You should hear an audible click. Check the
secure engagement to the base by pulling up on both sides. If it does not move
or tilt, the seating shell is now locked and has been installed properly.
f. Once locked into place, add the occupant for transportation and/or adjustment.
MK-100377 Rev. A
14 15 16a 16b 17 18
WARNING
18
E
14
VIII. USE AND MAINTENANCE
16a
16b
14
15
17