Description Of Symbols; Standard Equipment; Preparing The Machine For Operation; Attaching Wheel Axle And Wheels - Viking GE 150 Manual De Instrucciones

5. Description of symbols

Caution!
Read the instruction man-
ual before initial use.
Risk of injury!
Keep other persons out of
the danger area.
Risk of injury!
Rotating tools.
Keep hands and feet away
from apertures when
machine is running.
Risk of injury!
Switch off the motor and dis-
connect the power cable
from the machine before
working on the cutting tool,
before performing mainte-
nance and cleaning work,
before checking whether the
electric cable is entwined or
damaged and before leaving
the machine unattended.
38
Wear hearing protection.
Wear safety glasses.
Wear work gloves.
Risk of injury:
Do not climb onto the
machine.
Risk of injury:
Never put your hands or any
other part of your body or
clothing into the feed chute
or ejection chute.

6. Standard equipment

Item Designation
A Basic unit with lower chute
B Wheel carrier
C Wheel axle
D Wheel lock
E Screw, M6 x 55
F Hexagon nut
H Quick fastener
I Wheel
J Wheel cap
K Square nut
L Washer Ø 17 mm
M Bolt, M6 x 50
N Discharge flap
O Ejection chute extension
P Strip
Item Designation
Q Pin
R Torx screw P5 x 20
S Upper chute
T Safety screw
U Torx screw P5 x 10
V Combination spanner
•
Instruction manual
7. Preparing the machine for
operation
7.1 Attaching wheel axle and
wheels
● Attach the wheel axle (C) with
wheel locks (D), bolts (E) and hexagon
nuts (F) to the wheel carrier (B) and
tighten using combination spanner (V)
(4 - 6 Nm).
2 ● Push wheels (I) onto mounted wheel
axle.
Qty.
1 Quick fasteners must be pushed
onto the wheel axle only to the
1
extent that the wheels can still turn
1
freely.
2
Quick fasteners are not reuseable
2
following removal.
2
● Push the quick fastener (H) onto the
2
wheel axle with the convex side facing
2
outwards.
2
● Press wheel caps (J) onto wheels.
2
4
2
1
1
1
Qty.
2
3
1
4
2
1
1
3
0478 201 9906 D - EN