Service Schedule; Handover Confirmation; Possible Cause: - Blunt Blades; Service Confirmation - Viking GE 150 Manual De Instrucciones

– Feed chute not properly closed - safety
cut-off switch actuated (motorstop)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
– Check power cable and fuse
( 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) ( 10.1)
– Close feed chute properly and tighten
screws ( 11.2)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
( 11.3)
– Reset locking device (
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades (
Fault:
Shredding material is not drawn in
Possible cause:
– GE 260: Incorrect rotational direction of
blade disc
Remedy:
– GE 260: Change rotational direction of
blade disc ( 10.6)
48

20. Service schedule

20.1 Handover confirmation

8.6)
11.4)
11.7)

20.2 Service confirmation

Please hand this instruction manual
to your VIKING specialist dealer in
the case of maintenance work.
He will confirm the service operations
performed in the pre-printed boxes.
Service performed on
Next service date
24
0478 201 9906 D - EN