Tips And Recommendations For Installation - SOMFY Sunea Screen 40 io Manual De Instrucciones

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Sunea Screen?
Observations
The motorised product does
not operate.
The motorised product
stops too soon.
2.4.2. Replacing a lost or broken Somfy control point
Only switch off the power to the application to be reset.
This reset deletes all the local control points, however the sensors, end limit settings and favourite position are retained.
Position the motorised product at the mid-height position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised product moves for a few
5)
seconds. (If the application is in the upper or lower limit position, it will make a
brief up and down movement).
Press the PROG button on the new control point until the motorised product
6)
moves up and down: the new control point is programmed and all the other control
points are deleted.
Copyright © 2016 Somfy SAS. All rights reserved.
Possible causes
The wiring is incorrect.
The overheating protection on the drive has
been activated.
The control point battery is low.
The control point is not compatible.
The control point used has not been
programmed into the motor.
The crown is incorrectly positioned.
The end limits have been incorrectly set.
Solutions
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check whether the battery is low and replace it if
necessary.
Check for compatibility and replace the control point if
necessary.
Use a programmed control point or program this control
point.
Fit the crown correctly.
Readjust the end limits.
1
3
ON
5
ON
Images not contractually binding
EN
2
OFF
2 sec.
4
OFF
10 sec.
2 sec.
6
PROG.
29