Use And Maintenance; Up And Down Buttons; Stop Function; Favourite Position (My) - SOMFY Sunea Screen 40 io Manual De Instrucciones

EN
2.4.3. Restoring the original configuration
Only switch off the power to the application to be reset.
This reset deletes all control points, sensors and end limit settings and resets the drive's favourite position (my).
Position the motorised product at the mid-height position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised product moves for a few
5)
seconds. (If the application is at the upper or lower end limit, it will make a brief
up and down movement).
Press the PROG button on the Somfy local control point for ≈ 7 seconds, until
6)
the motorised product moves up and down twice:
The drive is reset to the original configuration.
Repeat the commissioning procedure (see the Commissioning section).

3. USE AND MAINTENANCE

This drive is maintenance-free

3.1. UP AND DOWN BUTTONS

Pressing the Λ or V button fully raises or lowers the motorised product.

3.2. STOP FUNCTION

The motorised product is moving.
Briefly press my: the motorised product stops automatically.

3.3. FAVOURITE POSITION (my)

To use the favourite position (my): Briefly press my: the motorised product starts to
move, and stops in the favourite position (my).
To program, modify or delete the favourite (my) position, see the section on

Additional settings.

3.4. OPERATING WITH A SOMFY SENSOR

Refer to the corresponding instructions.
3.5. ADDITIONAL SETTINGS
3.5.1. Programming or modifying the favourite position (my)
Place the motorised product in the desired favourite position (my).
1)
Press my for ≈ 5 seconds until the motorised product moves up and down: the
2)
desired favourite position (my) has been programmed.
30
Images not contractually binding
1 2
3 4
ON
10 sec.
5 6
ON
PROG.
1
2
3
2
1
Copyright © 2016 Somfy SAS. All rights reserved.
OFF
2 sec.
OFF
2 sec.
my
X2