Cleaning The Charger - Medtronic Guardian Link 3 Manual Del Usario

Note: During testing, Medtronic MiniMed used Detachol to remove the adhesive residue
from the transmitter. Detachol is recommended for use but may not be available in
all countries.
To remove adhesive residue:
1 Make sure the tester is attached to the transmitter.
2 Holding the tester, saturate a cotton swab in the Detachol solution and gently rub the
adhesive residue on the transmitter until it is fully removed.
3 Continue with the appropriate single-patient or multiple-patient cleaning procedure.
See Cleaning the transmitter, on page 9 for details.

Cleaning the charger

This procedure is for general cleaning as required, based on physical appearance.
Caution: Do not immerse the charger in water or any other cleaning agent. The
charger is not waterproof. Water can damage the charger, and cause
the device to malfunction.
Warning: Dispose the charger according to the local regulations for battery
disposal, or contact your healthcare professional for disposal
information. The charger may ignite upon incineration.
Warning: For multiple-patient use, always clean and disinfect the transmitter after
removing it from the patient and before attaching it to the charger. If
blood comes in contact with any surface areas of the charger, the
contaminated device must be discarded. The charger contains a battery
which may ignite upon incineration.
To clean the charger:
1 Wash your hands thoroughly.
-18-