Cleaning The Charger - Medtronic MiniLink REAL-Time Manual Del Usaurio

Removing adhesive residue
You may need to perform this procedure only if you have used optional occlusive
dressing, which may leave adhesive residue on the transmitter. If you visually inspect the
transmitter and see adhesive residue on it, follow the instructions below.
To remove adhesive residue, you will need the following materials: Detachol
adhesive remover and cotton swabs. You can buy Detachol
http://www.medtronicdiabetes.com, or by calling 800 646 4633.
To remove adhesive residue:
1 Make sure the tester is attached to the transmitter.
2 Holding the tester, saturate a cotton swab in the Detachol solution and gently rub the
adhesive residue on the transmitter until it is fully removed.
3 Continue with the appropriate single-patient or multiple-patient cleaning procedure
above.

Cleaning the charger

The charger cannot be disinfected. This procedure is for general cleaning as required,
based on physical appearance.
Caution: The charger is NOT waterproof. Do NOT immerse in water or any other
cleaning agent.
Caution: Dispose the charger according to the local regulations for battery
disposal (non-incineration).
®
at http://www.amazon.com/,
-18-
®
medical