Section 1. General Information; Introduction; Consumer Information And Safety; Spa/Hot Tub Safety Rules - Jandy JE Serie Manual De Instalación Y Operación

|
Jandy ® JE Heat Pumps

Section 1. General Information

1.1

Introduction

This manual provides installation and operation
instructions for the Jandy JE models of heat pumps.
Read these installation and operation instructions
completely before proceeding with the installation.
Consult Zodiac Pool Systems, Inc. ("Zodiac") with any
questions regarding this equipment. To obtain additional
copies of this manual contact us at 800-822-7933.
Zodiac Pool Systems, Inc.
2620 Commerce Way
Vista, CA 92081 USA
The Jandy JE heat pump gets electrical power from an
external source and provides a dual digital thermostat
control system for pool/spa combinations or preheat
convenience.
This heat pump is specifically designed for heating
fresh water swimming pools and spas. Do not use it
as a general service heater. Consult your dealer for the
appropriate Zodiac products for these applications.
®
NOTE "Fresh water swimming pools and spas" include
systems that utilize saltwater chlorine generator
units, such as the Zodiac AquaPure
Chlorine Generator. Please ensure that the salt
content of the pool/spa does not exceed
4500 ppm and water flow rate is within
30-70 gpm (110-265 lpm).
ATTENTION
Installation and service must be performed by
a qualified installer or service agency.
After installation, these
To the Installer:
instructions must be given to
the homeowner or left on or
near the heat pump.
This manual contains
To the User:
important information that
will help you in operating and
maintaining this heat pump.
Please retain it for future
reference.
1.2

Consumer Information and Safety

The Jandy JE series of heat pumps are designed
and manufactured to provide many years of safe
and reliable service when installed, operated and
maintained according to the information in this manual
and the installation codes referred to in later sections.
Throughout the manual, safety warnings and cautions
are identified by the " " symbol. Be sure to read and
comply with all of the warnings and cautions.
Installation and Operation Manual
Electronic
®
ENGLISH

Spa/Hot Tub Safety Rules

WARNING
The U.S. Consumer Product Safety Commission
warns that elevated water temperature can
be hazardous. Consult heater operation and
installation instructions for water temperature
guidelines before setting temperature.
WARNING
The following "Safety Rules for Hot Tubs,"
recommended by the U.S. Consumer Product
Safety Commission, should be observed when
using the spa.
WARNING
Spa or hot tub water temperature should never
exceed 104°F (40°C). One hundred degrees
Fahrenheit (100°F [38°C]) is considered safe for
a healthy adult. Special caution is recommended
for young children.
WARNING
The drinking of alcoholic beverages before or
during spa or hot tub use can cause drowsiness
which could lead to unconsciousness, and
subsequently result in drowning.
WARNING
Pregnant women take note! Soaking in water above
102°F (38.5°C) can cause fetal damage during the
first three (3) months of pregnancy (which could
result in the birth of a brain-damaged or deformed
child). If pregnant women are going to use a spa or
hot tub, they should make sure the water temperature
is below 100°F (38°C) maximum.
WARNING
The water temperature should always be checked
with an accurate thermometer before entering a spa
or hot tub. Temperature controls may vary by as
much as 1F° (1°C).
WARNING
Persons with a medical history of heart disease,
diabetes, circulatory or blood pressure problems
should consult their physician before using a hot tub
or spa.
WARNING
Persons taking any medication which induces
drowsiness (e.g., tranquilizers, antihistamines, or
anticoagulants) should not use spas or hot tubs.
Page 3