Installation; Commissioning; Programming Door Operator; Programming With Remote Transmitter - Cardo Door Ultra excellent Instrucciones De Uso

Installation

See instructions for installation on page 121.
Installation steps D, Page 122:
• 1. Tighten the drive belt tensioning nut until the drive belt
no longer rests on the guide rail (equivalent to
X dimension).
• 2. Use the tensioning nut to increase the drive belt
tension to correspond to the length of the door operator
(B dimension).

Commissioning

After operation is completed, re-install light disk. See Chapter
L, Page 127.
• Slowly open the door by hand until you hear the slide snap
in.
• Connect the power supply. The "ready for use" (D) LED
lights up.

Programming door operator

ATTENTION: The overload cut-out provides no
protection whilst programming the door operator!
Note: Programming is only possible during initial installation
or after resetting the door operator. Do not press any keys
during programming.
Preparation: Connect door to door operator.

Programming with remote transmitter

At the time of delivery and after resetting the door
operator, the remote transmitter has the following
functionalities:
• 1 Safety control operation and fine adjustment "ON"
• 2 Safety control operation and fine adjustment "OFF"
• 3 and 4 confirmation (saving)
After the programming of the door
operator, key 1 is used for remote
control and the other keys can be
used to control other similar door
operators or other radio receivers.
Programming
• Press and hold key 1 and the
door moves in the open direction.
• If you have reached the desired end position "OPEN",
release key 1. (You can make corrections with key 2)
• Press key 3 once briefly, storage procedure: The door
operator automatically saves "End position OPEN /
CLOSE" and forces of the "Travel path OPEN / CLOSE".
The door operator lighting flashes.
The storage is complete when the door is open and the door
operator lighting lights up.
Check the overload cut-out according to the chapter
on safety checks

Programming without remote transmitter

On the door operator:
Ultra excellent
• Pull out the RJ-45 plug 3A
• Press and hold down "pulse" H and
the door moves in the open
direction.
• If you have reached the desired end
position "OPEN" position, release
"pulse" H key
• Re-insert the RJ-45 plug 3A (You
can make corrections with the
"pulse" H key)
• Press „Program" B key, Storage
procedure: The door operator
automatically saves "End position
OPEN / CLOSE" and forces of the "Travel path OPEN /
CLOSE". The door operator lighting flashes.
Saving is complete when the door is open and the door
operator lighting lights up.
Check overload cut-out according to the chapter on
safety checks.

Program/Delete remote transmitter

Programming remote
transmitter:
• Press the "Program" B key ,
LED C flashes once
• Within 20 sec, press a key on
the remote transmitter that
has not yet been
programmed, LED C lights up
and programming is
complete.
Delete (all) remote transmitter(s)
Press and hold "Program" B >key for 5 sec, LED C first
flashes slowly and then quickly and afterwards, it goes off. All
remote transmitters programmed have been deleted.

Operation

CAUTION. Mishandling of product can result in
injuries or material damage. Observe the basic safety
rules:
While opening or closing door, do not block travel areas
inside and outside. Keep children away.
The door movements can be activated or stopped through the
remote transmitter provided or through optionally
connectable switching elements such as the wall-mounted
push-button.
Optional external features (such as the emergency lock
release) can also be connected to the door operator.
The door must be connected before starting up
the operator. If it is not, incorrect force values
will be programmed into the electronics. This can cause
malfunctions.
1
2
3
4
5
A
E
A
B
H
B
C
9