General Problems / Troubleshooting; Changing The Fuse; Changing The Battery Of The Remote Transmitter; Maintenance Intervals - Cardo Door Ultra excellent Instrucciones De Uso

General Problems / Troubleshooting

Description Possible sources / Troubleshooting
The door operator The door encounters an obstruction
light flashes Perform performance test
Safety device does Wrong setting of door or entrapment
not function protection system / Reset and
reprogram
The door operator No power supply or wrong power
does not function at supply / The fuse of the motor
all control is defective / Check external
terminals A3 and 4
The door operator is The carriages are not properly
defective engaged / The drive belts are
wrongly tensioned / The door
thresholds are iced up
The door operator Check door for proper functioning
switches off during and entrapment protection system /
motion Program door operator / Reset
Remote transmitter Renew battery
does not function,
LED does not flash
Remote transmitter LED C on the control system does
does not function not light up while operating remote
transmitter: Programming remote
transmitter. / Poor reception (Install
optional antenna)
The operator cannot Check wall-mounted push-button
be operated through and control wire
the wall-mounted
push-button
(optional)

Changing the fuse

Pull out mains plug.
Unscrew fastening screw of the control system and
pull out control device The fuse is located inside it, beneath
the side cover.

Changing the battery of the remote transmitter

Take off housing cover. Remove batteries, change them and
replace housing cover.
Use only leak-proof batteries. Make sure the polarity
is right. Dispose of used batteries in an
environmentally-friendly way.

Maintenance intervals

Monthly
• Overload cut-out (Protection system)
• Emergency release / unlocking
• Additional safety features (if available)
Every 6 months
• Mounting of door operator on the ceiling and on the wall.

Declaration of conformity

See page 130.
12
Release light disk and remove.

Technical data

Mains connection
Fuse
Power requirement at rated load
No-load current
IP
Radio control
Remote transmitter range*
Remote transmitter battery
Running speed
(Load-dependent)
Closing force
Rated load
Ultra excellent
Ultra excellent long
Ultra excellent size 3
Ultra excellent size 4
Total length
Installation height
Ambient temperatures
allowed
Storage
Lighting
Maximum number of duty cycles
per hour at rated load
Maximum number of duty cycles
continuously at rated load
* The transmission range of the remote transmitter may
reduce considerably due to external interference.

Replacement Parts

See pages 128 and 129.

Accessories (Optional)

Available from specialised dealers:
• 4-command multiplex remote transmitter
• Wall-mounted push-button
• Key-operated control
• Keypad
• Remote Keypad
• External antenna
• Photo cell
• Optosensor
• Emergency lock release from outside or inside
• Safety rail 8.2 KOhm
• Potential-free receiver, different frequencies

Removal, Disposal

Removing the door operator takes place in the
reverse sequence of the installation instructions
and must be carried out by qualified technicians.
Dispose of the device according to environmental
guidelines. Electrical parts must not be disposed of
as domestic waste. 2002/96/EC (WEEE)
230 V~. 50 Hz
1.6 A, T (slow-blow)
170 W
< 4 W
only for dry rooms, IP20
433 MHz AM
15 - 50 m
CR 2032 (3V)
~ OPEN >100 mm/s
~ CLOSE >100 mm/s
800 N
240 N
2,540 mm
3,625 mm
4,710 mm
6,880 mm
Piston travel +810 mm
40 mm
-20 °C to + 50 °C
-20 °C to +80 °C
E14, max. 40 W
20
8
Ultra excellent